Anybus® PoE Injector 12–57 VDC STARTUP GUIDE SP2385 EN 1.
Important User Information Liability Every care has been taken in the preparation of this document. Please inform HMS Industrial Networks AB of any inaccuracies or omissions. The data and illustrations found in this document are not binding. We, HMS Industrial Networks AB, reserve the right to modify our products in line with our policy of continuous product development.
About This Document 1 3 (12) About This Document This document describes how to install Anybus PoE Injector 12–57 VDC. For additional documentation and technical support regarding this product, please visit www.anybus.com/support. Document Conventions The following formatting conventions are used in this document to indicate safety information and other content of specific importance: WARNING This instruction must be followed to avoid a risk of death or serious injury.
Description 2 4 (12) Description Anybus PoE Injector 12–57 VDC is a dual port 802.3af/at compliant Power over Ethernet injector with Midspan Intelligent Detection. The PoE injector will not turn on power until it detects a valid PoE signature from the devices attached downstream on the Ethernet cable. This protects noncompliant equipment against damage. Anybus PoE Injector 12–57 VDC will not function with equipment that is not fully compliant with the IEEE 802.3af/at PoE standards.
Installation 5 (12) 3 Installation 3.1 DIN Rail Mounting Fig. 2 DIN rail mounting kit 1. Attach the DIN rail mounting plate (included) to the back of the unit using the 3 included screws. 2. Hook the unit onto the DIN rail and press it downwards and towards the rail until it snaps into place. 3. To remove the unit, press downwards and pull the unit free from the DIN rail. Anybus® PoE Injector Startup Guide SP2385 EN 1.
Installation 3.2 6 (12) Wall Mounting Fig. 3 Wall mounting kit 1. Attach the 2 wall mounting brackets (included) to the top and bottom of the unit using the included screws. 2. Hold the unit upright against the wall and fasten it with suitable screws through the apertures in the brackets. Anybus® PoE Injector Startup Guide SP2385 EN 1.
Installation 3.3 7 (12) Overview Fig. 4 Front panel Anybus® PoE Injector Startup Guide SP2385 EN 1.
Installation 3.4 8 (12) LED Indicators PWR PoE 1 PoE 2 3.5 Green Power on Off No PoE device on 10/100 Mbit port Blue, blinking Detecting PoE device on 10/100 Mbit port Blue, steady PoE device link on 10/100 Mbit port Off No PoE device on Gigabit port Blue, blinking Detecting PoE device on Gigabit port Blue, steady PoE device link on Gigabit port Power Connector Fig.
Installation 3.6 9 (12) Ethernet/PoE Connectors Fig.
This page intentionally left blank
Appendix A: Technical Data 11 (12) A Technical Data A.1 Technical Specifications Order code AWB4006-B PoE standard IEEE 802.11 af/at Ethernet IN 2x RJ45 (Data, 10/100/1000 Base-T(x)) Ethernet OUT 2 x RJ45 (Data and power, 10/100/1000 Base-T(x)) Input voltage 12-57 VDC on 4-pin screw terminal block Output voltage 50 V / 600 mA, 30 W max.
last page © 2018 HMS Industrial Networks Box 4126 300 04 Halmstad, Sweden info@hms.se SP2385 EN 1.
