User's Manual

AnyDATA.NET Inc. AnyTime AnyPlace Any Wireless Data Solution
TM
4.5.2 UART2 R-UIM interface
The UART2 supports R-UIM interface.
Table 4-5.2 UART2 Interface Pinouts
Pin # Pin Name Main Function Type Description
20 VREG_UIM VREG_UIM O +3.0V power supply to RUIM card
21 UIM_P_DATA UIM_P_DATA I Data from RUIM card
22 UIM_P_RESET UIM_P_RESET O RUIM card reset
23 UIM_P_CLK UIM_P_CLK O RUIM clock
Leave unused Pins open.
If a customer wants to use R-UIM card, UART2 can’t be used as UART.
This feature is not implemented but can be added, please contact [e-mail] for technical support.
4.5.3 UART3 Debug Port Interface
The UART3 is used to monitor and diagnose the status of the DTEV-Dual. It is strongly recommended
for the user to have the following UART3 pins connected to an extra connector or to test points, in order to
easily troubleshoot any problems with the module.
Table 4-5.3 UART3 Interface Pinouts
Pin # Pin Name Main Function Type Description
26 GPIO_84 UART3_TXD O Transmit data output, DEBUG PORT
28 GPIO_85 UART3_RXD I
Receive data input , DEBUG PORT
16 GPIO_95 UART1_TXD O
Transmit data output, DEBUG PORT
18 GPIO_96 UART1_RXD I
Receive data input , DEBUG PORT
If USB is used for primary data, use Pin16 and Pin18 for debugging.
If UART1 is used for primary data and USB is not used, use Pin26 and 28 for debugging.
Leave unused Pins open.
This feature is not implemented but can be added, please contact [e-mail]
for technical support.
4.5.4 USB Interface
The module
contains Universal Serial Bus (USB) interface to provide an efficient interconnect
between the mobile phone and a personal computer (PC).It can act as a USB peripheral device, supporting
low speed 1.5 Mbps and full speed 12Mbps connections. In host mode, the module supplies VBUS with
+5Vdc at up to 25mA.
This module is USB V1.1 comparable.
All Rights Reserved.
AD-2001-06-28 Ver 1.1
-30-