User manual

6
3
Initial Installation
REPLACING FUSES
If the fuse blows, determine the cause, then correct the problem.
After the problem is resolved, replace the fuse. If newly installed fuses
continue to blow, disconnect the power cable and contact your autho-
rized dealer or an authorized servi-
cecenter for assistance.
Only use fuses of the specified type and rating, otherwise the
transceiver could be damaged.
After connecting the transceiver to the power supply, the supply voltage
can be displayed on LCD by pressing the
FUN
key together with the
key.
The display immediately changes as the voltage supply changes, It
also displays voltage during transmission.
The transceiver will return to its normal operation when the power is
switched ON or repeat above operation.
%HIRUHRSHUDWLQJLQVWDOODQHI¿FLHQW ZHOOWXQHGDQWHQQD7KH VXFFHVV
of your installation will depend largely on the type of antenna and its
correct installation. The transceiver can give excellent results if the
antenna system and its installation are given careful attention.
8VHDȍLPSHGDQFHDQWHQQDDQG ORZORVVFRD[LDOIHHGOLQHWKDW
KDVDFKDUDFWHULVWLFLPSHGDQFHRI ȍWRPDWFKWKHWUDQVFHLYHULQSXW
impedance. Coupling the antenna to the transceiver via feed-lines having
DQLPSHGDQFHRWKHUWKDQȍUHGXFHV WKHHIILFLHQF\RI WKHDQWHQQD
system and can cause interference to nearby broadcast television
receivers, radio receivers, and other electronic equipment.
Fuse Location Fuse Current Rating
Transceiver 15A
Supplied Accessory DC
power cable
20A
If you use the transceiver for a long period when the vehicle battery is
not fully charged, or when the engine is OFF, the battery may become
GLVFKDUJHGDQG ZLOO QRWKDYHVXI¿FLHQWUHVHUYHVWRVWDUW WKHYHKLFOH$YRLG
using the transceiver in these conditions.
The range of displayed voltage is only from 7V to16V DC, because the
displayed value is estimated, please use a voltmeter when a more precise
reading is desired.
Power supply voltage Display
Antenna Connection
,PSRUWDQW
Transmitting without first connecting an antenna or other matched
load may damage the transceiver. Always connect the antenna to the
transceiver before transmitting.
$OO¿[HGVWDWLRQVVKRXOGEHHTXLSSHGZLWKDOLJKWQLQJDUUHVWHUWRUHGXFH
WKHULVNRI¿UHHOHFWULFVKRFNDQGWUDQVFHLYHUGDPDJH
The possible locations of antenna on a car are shown as following: