User manual

31
10
Connect DC power cable with car battery.
Connect the optional alarm cable QL-01(A) to the data jack on
1.
the front panel as shown. Secure the other end of the cable to an
REMHFWWKDWVWD\V¿[HGLQYHKLFOH1RWHLIDODUPFDEOH4/$LV
not enough long, you can choose optional alarm cable QL-01 (B) to
extend).
When transceiver power off by press
2.
key ,the long-distance anti-theft
alarm enable.
Note:The long-distance anti-theft alarm only available when
3.
transceiver power off .
When the alarm cable QL-01(A) or QL-01(B) is removed from the
4.
DATA jack or cut by improper sequence, the alarm function enable
and will alarm as programmed. In alarming,the transceiver will stop
alarm once receiving
a matching signal. And alarm again when a
matching signal disappeared.
Restart radio to cancel anti-theft alarming.Reconnect with alarm
5.
cable and turn off radio,the system will return to alarm mode.
This function is mainly use for simple anti-theft alarm device in vehicles.
When the transceiver be removed in an improper manner,the transceiver
will emit and transmit alarming and background voice to system and
other transceiver of the same frequency.
Steering-wheel etc.
Alarm cable [QL-01(B)]
DC power cable
Battery
Alarm cable
[QL-01(A)]
Long-distance Anti-theft Alarm