Operating Manual

2.4

How to Charge

WARNING:

When keys, ornamental chain or other electric metals contact the

battery terminal, the battery may become damage or injure a human.

If the battery terminals are short circuited it will generate a lot of heat.

Take care when carrying and using the battery. Remember to put the

battery or radio into an insulated container. Do not put it into a metal

container.

Plug the AC adaptor into the AC outlet, and then plug the cable of the

AC adaptor into the DC jack located on the back of the charger. The

indicator light blinks orange and is then ready to charge a battery.

Plug the battery or the radio into the charger. Make sure the battery

terminals are good in contact with charging terminals. The indicator light

turns to red--- charging begins.

It takes approximately 2-5 hours to fully charge the battery. When the

lamp lights green, the charging is completed. Remove the battery or the

radio unit with its battery from socket

when charging a radio (with battery) the indicating lamp will

not turn into green to show the fully charged status if the radio

is powered on. Only when the radio is switched off will the lamp

indicate normal operation. The radio consumes energy when it

is power-on, and the charger cannot detect the correct battery

voltage when the battery has been fully charged. So the charger

will charge the battery in constant voltage mode and fail to

indicate correctly when the battery has been fully charged.

2. BATTERY INFORMATION

AT-D87 8UV Digital DMR and Analog UHF/VHF Two Way Radio