User`s manual

28
7
General Setting
Set the left band and right band as VHF (136~174MHz) and
UHF(400~470MHz)then turn of this function will enable Cross Band
repeater function.
Press
1.
key to enter function menu.
Switch the selector knob to choose No 44
2.
function. The LCD displays "X-RPT"
Press the Main band selector knob, the
3.
LCD displays "XSTART".
Press the Main band selector knob, the radio prompt “DU” and the
4.
LCD displays "RPT", the corss band repeat function is on.
Press
1.
key to enter function menu.
Turn the Main band selector knob to choose No. 45-47 menu. The
2.
LCD displays "COL RED","COL GRN","COL BLU"
Press the Main band selector knob to
3.
enter function setup.
Switch the Main band selector knob to
4.
choose wanted value.Each color (Red,
blue, Green) with 32 brightness levels.
Press the Main band selector knob or
5.
key to store value and back to
function menu. Press key or hold
selector knob for over 0.5 second to store
setup and exit.
CROSS BAND REPEAT
LCD BACKLIGHT
Press
1.
key to enter function menu.
Turn the Main band selector knob to
2.
choose No43 menu. The LCD displays "WINNAR"
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
WIDE: Wide band (25KHz)
MIDDLE: Middle band (20KHz)
NARROW: Narrow band (12.5KHz)
Press the Main band selector knob or
5.
key to store value and back to
function menu. Press key or hold
selector knob for over 0.5 second to store setup and exit.
WIDE/NARROW BAND
This function only valid when both bands work on VFO mode.
Press
will turn off cross band function.
NOTE
NOTE
Enable this function, the adjustment any band of VFO frequency,
will bring same frequency change to both bands. Adjust one gear, the
frequency for both band will increase or decrease one step size value.
Press
1.
key to enter function menu.
Turn the Main band selector knob to
2.
choose No42 menu. The LCD displays "VFOTR"
Press the Main band selector knob to enter function setup.
3.
Switch the Main band selector knob to choose wanted value.
4.
Available Values: ON, OFF.
Press the Main band selector knob or
5.
key to store value and back to function menu. Press key
or hold selector knob for over 0.5 second to store setup and exit.
VFO FREQUENCY LINKAGE