User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 127 of 148
6. Web Interface
6.1 TX WEB INTERFACE
The TX Control module provides a built-in web interface (192.168.1.210) that
enables remote monitoring and control of the TX. This Control Module interface may
be used for a variety of things, including turning the TX On/Off, manually switching
between exciters (in a DD configuration), monitoring the voltages and currents of the
PAs, calibrating the system and PA power meters, etc. Each Pa also has its own built-in
web interface (PA web interface: 192.168.1.200).
A built-in web interface also exists in the Exciter that may be used for such things
as adjusting the TX output power, performing corrections, etc. (please reference the
separate Exciter User Manual for a detailed description of the Exciter web interface).
The Control Module communicates with the Exciter(s) and PAs inside the TX via an
RS-485 bus network.
The Control Module built-in web interface is accessible via the rear panel LAN
RJ-45 connection, once networked to your PC, the Controller web interface may be
accessed via a web browser (such as Internet Explorer or Firefox, etc.) by entering the
IP address of the Controller (default 192.168.1.210, note: you can navigate to the
Network setting under the Config menu to view and change the Controller IP address).
Launching a web browser and entering the Controller IP address (192.168.1.210)
will bring up the following login window.