User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 67 of 148
 WIFI: Reserved.
 POWER: Power switch on/off.
 COM2/3/4: Serial port
 COM1: Serial port
 LAN2: To access to Ethernet.
 LAN1: To be connected to ANY1022 REMOTE(RJ-45).
 USB: two USB ports
 VGA
 HDMI
 DC9-24V: 24VDC voltage input.
The default IP Address of the ANY1022 is 192.168.254.254. In order to communicate
with the device through a web browser, configure the industrial PC (with 10”
touchscreen) to be on the same subnet as ANY1022. This will allow you to have access
to the ANY1022 Control Panel to tune network settings according to the required by
your network parameters.
After setting network parameters of the computer/device running a WEB browser (Host)
the following steps are recommended:
 Verify basic communication between the PC and ANY1022; you should be able to
connect to the ANY1022 using the WEB browser by entering the ANY1022’s IP
address and see its WEB UI main page. Please refer to Figure below;
 Make sure that the “Connection” bar is green and “Connected” status is present;