User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 80 of 148
Linear and Non-Linear corrections were performed and optimized at the TX rated
TPO in the factory and so the stored correction coefficients should produce good results
if you are operating at or close to the TX max output power.
If you are operating at a TPO less than the max rated TX power or wish to rerun
corrections, please reference the “Running Corrections” section of your transmitter
User Manual.
7. With your TX operating at your desired output power and with good RF
performance, the next step is to engage the TX AGC.
Navigate to the AGC screen on the Controller (by pressing the CONFIG button and
then the AGC button). Be sure the AGC Target FWD power is set your desired TPO
but no higher than the TX max rated output power, and then press the unlit AGC button
to engage the TX AGC and turn this button Green.