Use and Care Manual

Step 1
Put fireplace body (Part A) upside down and
insert support rods (part D) into each side,
across the inside of the body, so that the rods
line up with the pre-drilled set of holes on each
side the fireplace body.
We suggest you assemble your fireplace on a carpeted surface or on a towel to avoid any scratches to your floor or fireplace.
Please disassemble Rods (Part D) from fireplace body (Part A) by removing the screws and rubber washers
(Parts E/F) before beginning assembly steps below.
Step 2
Turn fireplace body on its side with the top facing away
from you and place first glass piece (Part B) on top of the
body so the holes in the glass line up with the holes in the
fireplace frame. It may help to have another person assist
in holding the glass steady when attaching.
Note: The fireplace is designed to be suspended between
the glass pieces 9 inches from the screws to the floor.
Holes in the glass are not centered vertically. The holes in
the glass are 9 inched from the intended bottom and
should be closer to you when attaching glass to frame.
When attaching the glass, make sure the underside of the
fireplace body is facing this intended bottom of the glass.
Step 3
Insert transparent washers (Part F) into holes in
glass and using the black screws (Part E) screw the
glass to the body. The screws attach to the support
rod in the underside of the fireplace so make sure
these are all in alignment.
Step 4
Turn fireplace onto is other side with the glass side
that you just attached on the towel or carpet with the
bottom facing you. Repeat Step 3 for this other side,
again keeping the shorter distance of glass edge to
the holes closer to you.
ASSEMBLY INSTRUCTIONS