Owners manual

5150 Eucalyptus Avenue Unit A
Read complete instructions
Chino, Ca. 91710
before installation!
888.360.3696
AnzoUSA™ products are covered, by a limited one (1) year warranty, to be free of manufacturer’s defects. However, certain AnzoUSA™
product categories have warranty policies which differ from this standard, please contact your representative for detailed category
information. Damage due to improper installation or road hazards is not covered. Seller and manufacturers’ only obligations shall be to
replace the product proven to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or
consequential, arising out of the use of or the inability to use the product. Before using, user shall determine the suitability of the
product for its intended use, and user assumes all risk and liability whatsoever in connection therewith.
Step 6: Reinstall the light on the
vehicle.
Step 7: Test all functions before
driving.
Tools needed: Phillips
screwdriver
Step 1: Locate the two phillips
screw and remove them.
Step 2: Take off the old third
brake light from the vehicle.
Step 5: Plug in the new Anzo
third brake light into the original
wire harness.
Step 4: Take out the new Anzo
led third brake light
Step 3: Unplug the wire
harness.
Application: 1994-2001 Dodge Ram
Part Number: 531046-531079-531078
Improper installation may
www.anzousa.com
void warranty
Description: 3rd Brake Light