Specification Sheet

ManualsBrandsAnzzi ManualsKitchen FaucetsBraccia 4 GPM Wall Mounted Double Handle Pot Filler with Double-Jointed Swinging Spout

Item:KF-AZ258**

INSTALL & OPERATION MANUAL

V1.0

ANZZI POT FILLER

DON’T WAIT!

recognized as an official purchase and is eligible for warranty

coverage.

Mail in the completed registry card (Pg. 2) or register online

at www.swcorp.com/register

1/2 NPT

4 g k 414 @ nim/L 1 .51 ,isp 06 @ mp Pa

Certiﬁed to

NSF/ANSI 61

Certiﬁed to

NSF/ANSI 372NSF/ANSI 61 NSF/ANSI 372

Summary of content (4 pages)

PAGE 1
Item:KF-AZ258** ANZZI POT FILLER INSTALL & OPERATION MANUAL V1.0 1/2 NPT 4 gpm @ 60 psi, 15.1 L/min @ 414 k Pa Certiﬁed to NSF/ANSI 61 Certiﬁed to NSF/ANSI 372 DON’T WAIT! REGISTER NOW! Register your product within 90 days to ensure your product is recognized as an official purchase and is eligible for warranty coverage. Mail in the completed registry card (Pg. 2) or register online at www.swcorp.com/register.
PAGE 2
PRODUCT REGISTRATION∗ IMPORTANT: YOUR WARRANTY WILL NOT BE RECOGNIZED UNLESS THIS CARD IS FULLY COMPLETED AND RETURNED OR ONLINE REGISTRATION IS COMPLETED. To ensure that your warranty is registered and confirmed please do one of the following: 1. Register online at www.swcorp.com/register. You will be asked to ﬁll out the same information you would in the registration card. Registering online is fast, secure and ensures we receive your information. 2.
PAGE 3
CRITICAL DIMENSIONS Tools Required Part [01] [02] [03] [04] [05] [06] [07] [08] Discription Faucet Flange Screw Anchor Plug Connector Hex Screw Allen Wrench Qty. 1 1 4 1 4 1 1 1 ATTENTION Be sure that each parts are in the package. OLD FAUCET: Always turn water supply OFF before removing existing faucet or disassembling the valve. Open faucet handle to relieve water pressure and ensure that complete water shut-off has been accomplished.
PAGE 4
the short side for the Connect to 1/2" IPS supply line. The pipe should extend 1/2" past the finished wall surface. Using the Connector[06] if needed. WARNING: Connect to Cold Water Only. Drill 15/64"(6 mm )holes where marked and install the Plugs[05]. Do not full tighten. Wrap plumber tape around pipe threads. Install the Anchor[04] using the 4 Screws[03] . Tighten Hex Screw[07] in Anchor[04]. Slide Flange[02] over the wall Anchor[04]. Tighten the Hex Screw[07] and mark the screw holes in the flange.