Installation Instructions

VESSEL SINK
INSTALLATION INSTRUCTIONS
Before installing, read entire Vessel Sink Installation Instructions. Observe all local building and safety codes.
Please inspect the unit immediately when received and report any damages right away to ANZZI’s customer service
center at 1-844-44-ANZZI.
Thank you for choosing ANZZI™ and enjoy your lovely new bath sink. We want to hear about your experience with us!
Please visit www.ANZZI.com and leave us a review. It will only take 5 minutes and we’d love to hear from you.
We recommend consulting a professional if you are unfamiliar with this type of installation. ANZZI accepts
TOOLS AND MATERIALS:
Silicone Sealant (for copper sinks, use Neutral Cure Silicone Sealant)
Damp Cloth
Basin Wrench
Thread Sealant
INSTALLATION
1. Carefully place the sink upside down on the counter with a towel
or other soft cloth beneath to prevent damage. Apply a
continuous bead of silicone to the base of the sink where it will
rest on the counter.
2. Turn the sink right-side-up and position it back over the 2" drain
hole.
3. Remove any excess silicone with a damp cloth. Let the silicone
dry for 24 hours. If a lavatory drain is included, move on to the
Drain Installation section.
DRAIN INSTALLATION
1. Disassemble the drain by removing the threaded tail piece, rubber sealing gaskets, friction washer and lock nut from
the drain body.
2. Place thread sealant on the threaded section of the tail piece and reattach to the drain body
sealing gasket up the tail piece to the top of the drain body. This gasket will create a water tight seal between the
3. Place the drain in the drain hole in the sink. On the underside of the counter, attach the tapered rubber gasket. With
4. Slide the friction washer up to meet the rubber gasket. Thread the lock nut onto the threaded shank. Hand-tighten
drain.
Perfection is our Tradition™