Installation Guide

ManualsBrandsANZZI ManualsShower DoorsSD-AZ03ABH-L

7 8 9

13 12

Handle

Single Rollers

Structural rail

Wall mounted bracket

ST5*40

Door side seal strip

Fixed glass panel

Moving glass panel

Top bracket

Structural arm

Glass support

Wall anchor(8)

Rubber seal

NO.

Qty

Drawing

Description

Componentlist

NOTE: Unpack your unit carefully and inspect it. Identify all parts using the detailed diagram and packing list

in this manual as a reference. Before discarding the carton, check for small hardware bags that may have

fallen to the bottom of the box. If any parts are damaged or missing, please contact ANZZI at

1-844-44-ANZZI or support@ANZZI.com.

SD-AZ03

SHOWER PANEL SERIES

Summary of content (4 pages)

PAGE 1
SD-AZ03 SHOWER PANEL SERIES 13 12 1 2 Componentlist 3 NO. Description 4 11 10 5 7 8 Qty 1 Rubber seal 3 2 Wall anchor(8) 5 3 Glass support 2 4 Door side seal strip 1 5 Fixed glass panel 1 6 ST5*40 5 7 6 Drawing Wall mounted bracket 2 8 Structural rail 1 9 Single Rollers 2 10 Handle 4 11 Moving glass panel 1 12 Top bracket 1 13 Structural arm 1 9 NOTE: Unpack your unit carefully and inspect it.
PAGE 2
Guard Rail Fixed Panel 1. Lay the structural guard rail (8) along the ground. Insert the two wall mounting brackets (7) at both ends of the structural guard rail. Mark on the wall where to drill the hole to allow the wall mounting bracket anchors to be installed. 3. Install the rubber seal (1) on to the side of the fixed glass panel (5). Then, install the glass supporting brackets (3) to the fixed glass panel. 2. Drill the holes with an 8mm drill bit and insert the white plastic anchors.
PAGE 3
Top Bracket Sliding Door 6. On the top side of the fixed panel install the top bracket (12). 8. Install the rollers to the sliding glass panel. Then install the remaining two rubber seal strippers on both ends of the sliding glass panel. 7. Insert the sliding glass panel (11) into place and install the top bracket on this panel as well. Make sure to line up both top bracket pieces. 9. Close the sliding glass door and inspect to make sure there is no gap between the sliding glass panel and the wall.
PAGE 4
Finishing 10. Position the structural arm (13) and install to the top mounting brackets and the wall. 11. Fix the handle (10) to the sliding glass panel. 12. Install the door side seal (4) to the fixed glass panel’s edge.