Installation Guide

22. Gently butt the vertical edge of the Stationary Glass (11) against the wall.
23. Securely hold the Stationary Glass (11) in place and close the Glass Door (01) while aligning it with the Stationary Glass. It may be necessary to adjust
the position of the Anti-Water Strip (19) to ensure a tight fit with the top and bottom of the Glass Door. From the interior of the shower, precisely outline the
placement of the Wall Brackets (24).
ATTENTION: Make sure the top of the Stationary Glass and top of the Glass Door are level.
24. Extent the Glass Door (01) open and gently place the Stationary Glass (11) nearby. Take the Wall Brackets (24) off the Stationary Glass.
Mark the hole on the wall by replacing Wall Brackets to the position outlined. Using a Ø 5/16” drill bit, drill a hole and insert the Wall Anchor (13). Use the
Big Flat Head Screws ST4.2x35 (15) to attach the Wall Brackets to the wall.
25. Replace the Stationary Glass (11) into its proper spot and position it tightly up to the Wall Bracket (24).
OUTSIDE
INSIDE
OUTSIDE
GLASS PANEL