Installation Guide

Style “B”: Support Bar* Assembly and Installation

NOTE: Use parts from Diagram “B” for the Support Bar* assembly and installation.

ATTENTION:

If width of the Stationary

Glass is 12” and over you

must install Support Bar*

for stability

27. Locate the Support bar* (12).

Adjust the bar to a proper position on the glass and the

wall. Level it horizontally. Hold it firmly and outline the

bracket’s position on the wall. Remove the Support

bar* and detach the wall bracket from it. Place the wall

bracket against its outlined position on the wall and

mark the drilling hole.

Drill the hole using Ø 5/16” drill bit, insert the Wall

anchor (13) and fasten the wall bracket to the wall with

the Big flat head screws* ST4.2×

55 (15). Attach the

Support bar* to the wall as shown on Fig 27.6 and

tighten the set screws and the glass holding screw to

secure the glass.

See Fig. 15 for details.

Fig. 15

Ø 5/16"

inside

outside