Installation Guide

2. Place a piece of flat timber (5/8” thick) on the threshold or

the shower base. Remove the corner pads from the Glass

door (01). Place the Glass door on the flat timber.

Carefully butt up the door with hinged side against the

wall, adjust its position and level it vertically.

ATTENTION:

Please check with a level and be sure that the door is

absolutely plumb.

See Fig. 2 for details.

Fig. 2

3. Hold the door in place and mark the drill

holes for both Hinges (05) on the wall.

Set the door aside and drill the holes in

the wall using Ø 1/4” drill bit.

Place the Glass door (01) back on the

flat timber and attach both hinges to the

wall with only two Countersunk screws

ST5×70 (04) on the hinge from outside

of the shower.

See Fig. 3 for details.

ATTENTION:

This door is extremely heavy and the

hinges on this door must be attached

to the studs or to preinstalled 2 × 6

wood reinforcement behind the wall.

3 .giF

5/8"

Ø 1/4"

outside