Installation Guide

6. Get three measurements:

 from the top edge of the Glass door (01) to the

upper body of the top Hinge (05);

 from the lower body of the upper Hinge to the

upper body of the bottom Hinge;

 from the lower body of the bottom Hinge to

1/16” above the shower base.

Cut the Side strip (06) according to the

measurements.

Notch the cut strips to be able to slide them into the

Hinge to cover the space to the wall.

Remove the timber plate, fully open the Glass door

and press the cut strips on the vertical edge of the

Glass door.

See Fig. 6 for details.

Fig. 6

7. Measure the bottom of the Glass door

(01) from the Side strip (06) to the

vertical edge on the Handle (02) side.

Cut the Bottom anti-water strip (07) to

the size of your measurement and notch

3/8” of the inner side of the Bottom

anti-water strip.

NOTICE:

Make sure the Handle side of the Glass

door tight to the Anti-water strip (07)

along the vertical edge when the door is

shut.

See Fig. 7 for details.

Fig. 7

Into the hinge

inside

outside

inside

outside

inside

outside

inside

outside

Handle side

strip end

3/8"