ANZZI GLASS SHOWER DOOR INSTALL GUIDE Models: SD-AZ10-01 Have questions? Call us at 1-844-44-ANZZI or email at info@anzzi.com.
GETTING STARTED Notice: This assembly requires two people due to the weight of the 4. Make sure the installation surface area is level, solid, and can sup- glass doors. Professional installers are highly recommended. port the entire weight of the unit and the walls are at right angles before beginning installation. Major problems may occur if the surface area 1. Carefully inspect all boxes and packages to make sure no damage isn’t level and side wall angles are abnormal.
PARTS LIST 2 1 3 1. (1x) Glass door 2. (1x) Handle 3. (6x) Wall anchor 4. (6x) Screw ST5x35 5. (2x) Hinge 6. (1x) Side water proof strip 7. (3x) Bottom water proof strip 8.
TUB DOOR DETAIL A 1. Use the predrilled holes and the included bolts to assemble the Hinges (05) on the Glass Door (01). 2. Put a piece of 5/8” thick timber on the bathtub. Place the Glass Door (01) and assembled Hinges (05) on the piece of flat timber. Butt the hinged side of the door against the wall and use your leveler tool to make A necessary adjustments to its position until it is fully level. NOTE: The door should be leveled vertically. 3. Accurately mark drill holes on the wall.
STRIPS / HANDLE 5. Clear away the flat timber and open the door. Fasten the Side Anti-Water Strip (06) over the Glass Door (01) vertical edge. Fasten the Bottom AntiWater Strip (07) over the Glass Door bottom edge. Use the predrilled holes on the Glass Door to install the Handle (02). WARNING: WAIT 24 HOURS BEFORE USING THE SHOWER ENCLOSURE TO ALLOW THE SILICONE GEL TO DRY COMPLETELY.
MAINTENANCE Guarantee a longer life of the hardware finish by wiping off the metal parts with a soft cloth after each use. Avoid using abrasive cleaners and products especially those that contain bleach, acid, or ammonia. In the case that these chemicals are used, thoroughly rinse the surface as soon as possible and wipe dry with a soft cloth. Stainless-steel surfaces should be cleaned once a week or as needed. When applying a stainless-steel polish or cleaner, work with the grain and not against it.