SHOWER DOOR INSTALLATION & CARE GUIDE For models: SD-AZ10-01 Please Note: This is a two person job. The glass doors are extremely heavy and it is highly recommended to use professional installers. For any questions or assistance simply call 1-844-44-ANZZI or visit us at www.ANZZI.com Rev.1.
Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are included in the package, by marking all the components on the “Detailed Diagram of Tub Door Components”. Examine boxes and packages for shipping damage. If the unit has been damaged, has a finishing defect, or has missing parts, please contact our customer support department within 3 business days of the delivery date. 2.
Detailed Diagram of Tub Door Components 3 1 4 5 6 2 7 8 Packing List 01 02 03 Glass door Handle Wall anchor 1pc 1pc 6pcs 05 06 07 Hinge Side anti-water strip Bottom anti-water strip 2pcs 1pc 1pc 04 Flat head screw ST5×35 6pcs 08 2mm, 4mm Hex wrench 1set NOTE: Unpack your unit carefully and inspect it. Lay it out and identify all parts using the detailed diagram and packing list in your manual as a reference.
Tub Door Installation 1. Assemble the Hinges (05) onto the Glass door (01) using the predrilled holes and the bolts. See Fig. 1 for details. 1 2 3 Fig. 1 2. Place a piece of flat timber (5/8” thick) on the bathtub. Take the Glass door (01) with the assembled Hinges (05) and place it on the flat timber. Push the door with the hinged side against the wall and adjust its position with the level. 5/8” NOTE: Make sure that the door is leveled vertically. See Fig. 2 for details. Fig.
3. Mark the drill holes on the wall. Set the Glass door (01) aside, drill the holes using Ø5/16” drill bit, and insert the Wall anchors (03). See Fig. 3 for details. Ø 5/16” 1 2 3 Fig. 3 4. Place the Glass door (01) back in position and secure the Hinges (05) to the wall using the Flat head screw ST5×35 (04). See Fig. 4 for details. 1 2 Fig.
5. Remove the flat timber and open the door. Attach the Side anti-water strip (06) over the vertical edge of the Glass door (01). Attach the Bottom anti-water strip (07) over the bottom edge of the Glass door. Install the Handle (02) using the predrilled holes on the Glass door. See Fig. 5 and Fig. 6 for details. 2 1 3 Fig. 5 Fig .
HOURS HEURES IMPORTANT WARNING: DO NOT USE THE SHOWER ENCLOSURE IN 24HOURS, SO THAT SILICONE GEL CAN GET TOTALLY DRY. Product maintenance To insure long lasting life for your acrylic back walls, wipe them off after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream based cleaners. Never use abrasive cleansers, metal brushes or scrapers that could scratch or dull the surface.
