Installation Guide

1. Affix the Wall Brackets (01) onto the Stationary Glass (02).

NOTE: Installation of the Glass Bottom Protection Seal (13) to protect the

glass bottom corner is not necessary if the shower enclosure is installed

directly onto the tile floor.

2. Carefully mark drilling holes on the wall through the Wall Bracket (01)

holes, then set the Wall Bracket aside in a safe place. Use a Ø 5/16” drill

bit to drill the holes before inserting the Wall Anchors (07). Add silicone

caulk around the holes on the wall and the wall profile. Reposition the

Wall Bracket into its designated spot and use the Countersunk Screws

ST5x35 (08) to secure it to the wall.

3. Measure the length of the shower or tub door size and draw an

accurate line on the wall according to the door size. Set the assembled

Stationary Glass (02) on the bathtub or shower base and push them

against the wall. Use a leveler tool to ensure they are fully level.

ATTENTION: Double check to make sure the Glass Panel is perfectly

vertical.

DETAIL A

Mark location

oh hole on wall

TUB DOOR