Installation Guide

6. Find the Support Bar (03) then adjust it to a proper angle that will provide adequate support for the glass and wall. Use a leveler tool to level it horizontally.
With the Support Bar firmly in place, outline the bracket’s position on the wall. Place the Support Bar in a secure position and disassemble the wall brackets.
Position the wall bracket against the outline you made on the wall and accurately mark the drilling hole. Use a Ø 5/16” drill bit to drill the hole before inserting
the Wall Anchor (07). Use the Countersunk Screw ST5x35 (08) to attach the Support Bar to the wall. See Figure 6.4 for details. Secure the glass by carefully
tightening the glass-holding screw and set screws.
ATTENTION: To prevent creating a metal to glass connection, use a clear rubber gasket.
DETAIL A
Mark
position
on wall
Mark hole
on wall
Ø
5
6
"
A
Figure 5
SUPPORT BAR