Installation Guide

7. This step will require an assistant to ensure safe and proper installation.
Attach the Hinges (04) onto the Stationary Glass (02), making sure to
keep the decorative non-screw side facing outwards. From the inside,
hang the Glass Door (05).
ATTENTION: Hold the glass door in position by using a 5/8” shim below
the door while hinges are attached.
ATTENTION: To prevent creating a metal to glass connection, use a clear
rubber gasket.
When hanging the door, begin at the top hinge. Be sure you do NOT lean
on, swing, bend, or reposition the Glass Door until all hinges are installed
securely. Moving the door could cause the glass to break or the hinges
to snap. Once the hinges are properly installed, check the movement of
the door by opening and closing it to ensure it moves smoothly. Make any
necessary adjustments until the door aligns with the stationary glass.
8. Attach the Towel Bar (06) to the Glass Door (05). Install the Anti-Water
Strip (09) over the vertical edge of the Glass Door (05) and the Bottom
Anti-Water Strip (10) over the bottom edge of the Glass Door.
Refer to Figure 9 for details.
9. Place caulk along the inner and outer side of the bottom and along the
stationary glass and wall profile outer edges. Carefully clean the silicone
by using the Silicone Cleaner (12) tool.
HINGES
A
DETAIL A
Attach Handle