Installation Guide

8
9. Fasten both female parts of the Guide rail
brackets (08) to their male parts on the walls.
Tighten the set screws on the Guide rail
brackets to secure the Upper guide rail
between the two walls.
See Fig. 10 for details
01 .giF
1
2
8.
See Fig. 9 for details.
9 .giF
8mm
1 2
333
4
Mark the drilling holes on the floor through the
predrilled holes in the .
Remove the Threshold, drill the holes in the
floor using Ø 5/16” drill bit and insert the
Small anchors Ø5/16” (18).
Apply silicone on the bottom of the Threshold
along the center line and around the holes, place
it back to the designated position and fasten it
to the floor with the Countersunk screw
ST4.2×35(16)
.
threshold (15)
.dlohserht ni swercs yb degamad ssalg yranoitats eht diova o T :etoN
it is necessary to use Glass bottom protection seal ( ) to
21
cover on the 2
screws on the bottom of sanitonary glass.
Glass bottom protection seal