Specification

1.Handle carefully with glass panel to avoid bumping, support it with wooden board,
paper or foam when it is placed on floor
2. If any size deviation between base and shower enclosure :
① Check if it is wrongly installed;
② Check tilt level of enclosure against wall,
③ Contact our customer service if any problem
I n s t a l l a t i o n s t e p s :
1. Installation of base:
① Lay down base；
② Check base level, keep it fully flat by padding
or rubbing.
picture 1
2. Installation of frame:
① As picture 2 : fix roller into top guaid rail,
② Lock vertical jamb and guaid rail with screw ST4*40
③As picture 2 : insert wall jamb into frame
ST4*40
15
picture 2
3
14
18
16
12
3. Installation of wall jamb:
1.Put frame on the base
2. Mark drilling hole with pencil , drill hole , and insert rubber seal into the hole,
② As picture 4: Put wall jamb of moving glass panel into hole on the wall , lock it with screw.
ST4*25
17
1
picture 3
picture 4