ANZZI GLASS SHOWER DOOR INSTALL GUIDE Models: SD-AZ11-01 SD-AZ8076-01 Have questions? Call us at 1-844-44-ANZZI or email at info@anzzi.com.
GETTING STARTED Notice: This assembly requires two people due to the weight of the 4. Make sure the installation surface area is level, solid, and can support glass doors. Professional installers are highly recommended. the entire weight of the unit and the walls are plumb before beginning installation. Leveling adjustments and drilling may be necessary depending 1. Carefully inspect all boxes and packages to make sure no damage on the unit being installed. occurred during shipping.
PARTS LIST 2 1 3 3 6 7 4 5 6 1. (2x) Wall bracket 2. (1x) Glass panel 3. (1x) Bar 4. (2x) Hinge 5. (1x) Glass door 6. (1x) Towel bar 7. (3x) Wall bracket 8. (3x) Screw ST5x35 9. (1x) Anti-Water strip 10. (1x) Bottom anti-water strip 11. (1x) Bottom bracket 12. (1x) Silicone cleaner 13.
DETAIL A TUB DOOR 1. Affix the Wall Brackets (01) onto the Stationary Glass (02). A NOTE: Installation of the Glass Bottom Protection Seal (13) to protect the glass bottom corner is not necessary if the shower enclosure is installed directly onto the tile floor. Mark location oh hole on wall 2. Carefully mark drilling holes on the wall through the Wall Bracket (01) holes, then set the Wall Bracket aside in a safe place. Use a Ø 5/16” drill bit to drill the holes before inserting the Wall Anchors (07).
GLASS BRACKETS DETAIL A 4. Disassemble the Bottom Bracket (11). Insert the base of the Bottom Bracket into the notch found on the bottom of the Stationary Glass (02) from the inside. Precisely mark the drill hole on the bathtub, tray, or threshold. Gently remove the glass. Use a Ø 1/8” drill bit to drill the hole Mark here and use the Round Head Screw ST5x35 (08) to secure the base of the Bottom Bracket. 5. Reposition the Stationary Glass (02) back into the Wall Bracket (01).
SUPPORT BAR 6. Find the Support Bar (03) then adjust it to a proper angle that will provide adequate support for the glass and wall. Use a leveler tool to level it horizontally. With the Support Bar firmly in place, outline the bracket’s position on the wall. Place the Support Bar in a secure position and disassemble the wall brackets. Position the wall bracket against the outline you made on the wall and accurately mark the drilling hole.
HINGES 7. This step will require an assistant to ensure safe and proper installation. Attach the Hinges (04) onto the Stationary Glass (02), making sure to keep the decorative non-screw side facing outwards. From the inside, hang the Glass Door (05). DETAIL A ATTENTION: Hold the glass door in position by using a 5/8” shim below the door while hinges are attached. ATTENTION: To prevent creating a metal to glass connection, use a clear rubber gasket. When hanging the door, begin at the top hinge.
MAINTENANCE Guarantee a longer life of the hardware finish by wiping off the metal parts with a soft cloth after each use. Avoid using abrasive cleaners and products especially those that contain bleach, acid, or ammonia. In the case that these chemicals are used, thoroughly rinse the surface as soon as possible and wipe dry with a soft cloth. Stainless-steel surfaces should be cleaned once a week or as needed. When applying a stainless-steel polish or cleaner, work with the grain and not against it.
