Installation Guide
10
2
This shower door must be mounted to a stud. Minimum threshold space is required.
IMPORTANT: Using a stud finder, ensure the wall intended to hold the door has a
stud at the installation point. A stud in this location must be identified to support the
support bar in order to proceed with the installation. If there is no stud in the shown
area, we recommend employing a qualified contractor to install one. (Fig 2.1)
Using a pencil and stud finder to mark the center line of stud. Mark the center line
of stud on one side as measurement "A" then mark the center line of stud with same
measurement on t
he other side. Make sure the distance between
center line of stud
and the inner surface of threshlod is bigger than 1.57" [40mm] and the distance
between center line of stud and the outer surface of threshlod is bigger than 1.57"
[40mm]. (Fig 2.1)
Mark the position for outer surface of Bottom Rail with measurement 1.57" [40mm]
from the center line of stud on both side. (Fig 2.2)
1.
2.
[15]
center line of stud
center line of stud
1.57 [40mm]
[40mm]
1.57
A
A
[40mm] (min)
1.57
stud
[40mm] (min)
center line of stud
1.57
1.57
[40mm]
outer surface
of Bottom Rail
outer surface
of threshold
inner surface
of threshold
2.1
2.2