Installation Guide

12
Use a matched Allen Key [11] to stick into the side hole of Fixed Blocks [07] to
remove it and the Washers from t
from b
he Support Bar [03] and install the Support Bar [03]
to the Fixed Panel [02] ehind. Slide the Washers onto the Fixed Panel [02] and
secure with Fixed Block [07]. (Fig 4.1)
Note: Make sure the hole closest to the edge of the Fixed Panel [02] is far away
from the wall. There are Gaskets between the Support Bar [03] and the Fixed
Panel [02].
Remove the Corner Protectors except the one at the top right corner of Fixed Panel [02].
Install Water Sealing Strip [13] to the Fixed Panel [02]. Make sure the end of
Water Sealing Str
ip [13] is 0.5" from the bottom of Fixed Panel [02
]. (Fig 4.1)
If the
Water Sealing Strip [13] is longer than the Fixed Panel [02] after installation,
cut it to correct length. (Fig 4.2)
Install the Glass Bottom Protection Seal [21] to the bottom of Fixed Panel [02].
Note: Failure to install the Glass Bottom Protection Seal [21] will avoid the warrenty.
(Fig 4.2)
Install the Wall Brackets [08] back to the Support Bar [03]. Install the Fixed Panel [02]
to the Bottom Rail [15].(Fig 4.2)
1.
2.
3.
4.
5.
2
[03]
[21]
[08]
[15]
1.5"
(38mm)
4
4
Corner
Protector