Installation Guide

13
Hold the Fixed Panel [02] still. Adjust the Fixed Panel [02] and Support Bar [03] to
the vertically level and horizontally level. If necessary, loose the Fixed Blocks [07] for
the adjustment. Tighten the Fixed Blocks [07] again after the adjustment. (Fig 5.1)
Slightly push the Wall Brackets [08] to the wall and mark the outline of it on the wall.
T
NOTE: Make sure the Glass Bottom Protection Seal [21] still attaches at the bottom of
Fixed Panel [02] and slightly place it with cloth or blanket between the panel and the floor.
hen, remove the Fixed Panel [02] and Support Bar [03]. (Fig 5.1)
Place the Wall Brackets [08] on the marked location and mark the center hole on
the wall. (Fig 5.2)
Remove the Wall Brackets [08] and drill a 3/8" hole at each location. (Fig 5.3)
Insert the
White Plastic Anchor [09]. (Fig 5.4)
Attach and secure the Wall Bracket Plate using the Screw 5X40 [10].
The side with
three holes face to the wall.(Fig 5.5)
1.
2.
3.
4.
5.
6.
[02]
[03]
3/8"
[10]
[22]
Wall Bracket Plate
[09]
[08]
1
2
3
5
[07]
[11]
4
5
5