Installation Guide

Remove Screw, Eccentric Block, and Washer from the Roller [04]. Install the Roller

[04]

o the Door Panel [05] as the figure shows. Using one provided small Allen Key [11]

to stick into the side hole of Roller [04] and press the Stopper of it. Slightly tighten

the Screw by another matched Allen Key [11] to secure the Roller [04]. (Fig 6.1, Fig 6.2)

IMPORTANT: Make sure there is Washer between the Roller [04] and the Door Panel

[05]. Holes for the Door Panel [05] should be on the right when the Rollers [04] face

outside. (Fig 6.1, Fig 6.2)

Remove two of the Corner Protec

tors

and install the Water Sealing Strip [13] to the

right side of Door Panel [05]. Make sure the end of Water Sealing Strip [13] is aligned

with the bottom of Door Panel [05]. If the Water Sealing Strip [13] is longer than the Door

Panel [05] after installation, cut it to correct length. (Fig 6.1, Fig 6.3)

NOTE: Slightly place Door Panel [05] with cloth or blanket between the panel and the floor.

arefully move the Door Panel [05] to the shower room. (Fig 6.3)

[04]

[13]

holes on the right

cloth or blanket under the panel

[11]

Washer

align

Stopper

Eccentric Block

side hole

Screw

Corner

Protector