Installation Guide

17
Carefully lift up the Door Panel [05] and place the Roller [04] on the
Support Bar [03]. (Fig 9.1)
Use a matched Allen Key [11] to unscrew the Limit Stop [01] on the door side and
adjust it to the position 2.76" minimum away from the wall. Tighten the screw of
Limit Stop [01] to secure it. Slightly push the Door Panel [05] to the wall. The
Water Sealing Strip [13] should be touched the wall. If it doesn't, adjust the
position of the Limit Stop [01] again. (Fig 9.2)
Loosen the Screw of Roller [04] and adjust the Eccentric Block until it's side hole
points upward. (Fig 9.3)
Stick a ma
tched
Allen Key [11] to the side hole of Roller [04]. Hold the Allen Key [11]
still and tighten the Screw with another matched Allen Key [11]. (Fig 9.4)
Slightly push the Door Panel [05] to the wall to check if the Water Sealing Strip [13]
align with the wall. If it doesn't, loosen the Screw of Roller [04] and turn the
Eccentric Block to adjust the position of Door Panel [05]. Adjust the other Roller [04]
if needed. Remember to retighten the screw after the adjustment. (Fig 9.4)
Unscrew another Limit Stop [01] on the Fixed Panel [02] side and adjust it to the
position 3.6" minimum away from the wall. Tighten the screw of Limit Stop [01] to
secure it.
1.
2.
3.
4.
5.
6.
[05]
[03]
[11]
[11]
[11]
[01]
1
2
3
4
5
side hole
side hole
Eccentric Block
Screw
Screw
[11]
[01]
3.6[90mm]
2.76[70mm]
9
9