Installation Guide

18
Disassemble the Roller Guards [19] and install it to the Door Panel [05] as the
figure shows. (Fig 10)
Install the Rod and one Washer from the front of the Door Panel [05], install the
Nut assembly
from the back of Door Panel [05].
Hold the Rod by hand and use a matched
A
close to the Support Bar [03], turn the Nut in counter-clockwise.
llen
Key [11] to stick to the side hole of the
Nut and tighten it to secure. If the Rod is too
1.
2.
[11]
[19]
[03]
[05]
Washer
Rod
Nut
side hole
10
10