Installation Guide

19
Remove the Corner Protectors and install the Water Sealing Strip [17] to the side of
Door Panel [05]. Make sure the end of Water Sealing Strip [17] installed to Door Panel
[05] is aligned with the bottom of it. If the Water Sealing Strip [17] is longer than the
Door Panel [05] after installation, cut it to correct length. The flange should be faced
outside. (Fig 11.1)
Remove the Corner Protectors and install the Water Sealing Strip [17] to the side of
Fixed Panel [02]. Make sure the end of Water Sealing Strip [17] installed to Fixed
Panel [02] is 0.08" [2mm] above f
rom the
Bottom Rail [15]. If the Water Sealing Strip
[17] is longer than the Fixed Panel [02] after installation, cut it to correct length. The
flange should be faced inside. (Fig 11.3)
Cut a section from the top of the Water Sealing Strips [17] using the measurements from
Fig 11.2 & Fig 11.4.
1.
2.
3.
4
3
2
1
flange
flange
[17]
[17]
4.7"
4.7"
[120mm]
[120mm]
11
11
Corner
Protector