Installation Guide

10. Place the Guide block (12) on the floor and parallel it to the Stationary glass panel with its

edge flush with the glass vertical edge. Take a measurement to ensure the distance from the

outer surface of the glass to the center line of the guide block is 2 3 /16, hold it firmly and

mark hole positions on the floor. Remove the block, drill holes in the floor, insert anchors in

and then secure it onto the floo

r with the Countersunk screw ST4.2×30 (16).

ee fig.

11 for

details.

Fig. 11

11. Attach two Rollers (04)

to the

Glass door (05)

Suspend the door by hanging the

Rollers

onto the

Upper guide rail (03)

and slide the bottom edge of the

Glass door

into the groove of the

Guide block (12).

Adjust the fasteners on both Rollers to ensure that the

bottom edge of the

Glass door does not touch the

bottom of the

Guide block

Then mount two

Roller guards (20)

on the door to

secure the door to the Upper guide rail.

See Fig. 12 for details.

Fig. 12