Full Product Manual

Step 2
Remove Wall Jamb[021] and drill a 1/4"
hole at each location marked for Wall
Jamb[02] (Fig 3).
Wear safety glasses and cut-resistant,
non-slip gloves when drilling or cutting
to avoid risk of injury.
ATTENTION
8
Fig3
Step 3
1.Insert Wall Plugs[22] in each hole location.
2.The Wall Plugs[22] should fit securely into the
holes. If needed, a rubber mallet can be used to
insert Wall Plugs.
3.To reduce risk of property damage, the use of
metal hammers is not recommended. If needed,
use drill to slightly enlarge the opening of the hole
(Fig. 4).
IMPORTANT: Wall Plugs[22] MUST be used.
[22]
Fig4