Full Product Manual

Step 8
1.Measure the finished opening width at the model height("W1").
IMPORTANT: No need for cutting if the Support Bar[03] match the width. If they
don’t, please see Step 2.2 for cutting instructions (Fig 9.1).
2.Using a pencil or another marking tool (such as masking tape), mark distance
"W1, subtract 11/16"(17.5mm) " on the Support Bar[03] ( to leave some space
for the Wall Bracket [18]).
IMPORTANT: Double check the measurements before cutting. Cut the Support
Bar[03] with a fine toothed (32 TPI) hack saw. If needed, use a metal file to smooth
roughedges. Clean up metal shavings.
DO NOT stand on or use a vice to hold the Support Bar[03] while cutting.
Fig9
W1
W1
1
11