Full Product Manual

Fig11
Step 10
1.Using a pencil or other marking tool (such as masking tape), mark the position of the
Wall Bracket [18] (Fig 11.1).
2.Remove the Support Bar[03] and dissamble the Wall Bracket [18] from the Support
Bar[03] .
3.Mark the screw hole locations (Fig 11.2).
4.Drill a 1/4" hole to accept the Wall plug [22] (Fig 11.3).
IMPORTANT: To avoid risk of injury or product damage, make sure that you drill into studs.
5.Insert Wall plug [22] in hole location. If needed, a rubber mallet can be used to insert
anchor.To reduce risk of property damage, metal hammers are not recommended to be
used. If needed, use drill to slightly enlarge the opening of the hole (Fig 11.4).
IMPORTANT: Wall plug [22] MUST be used.
13
2
3
01/4"
4
1
[22]