Full Product Manual

Fig12
[4]
5
4
Step 11
1.Disassemble the gasket and anchor from the Wall Bracket [18] . Attach the gasket
and anchor to wall using Screw ST5x35[19] . Use drill to start screws into anchor.
Next, use a screwdriver to hand tighten until secure (Fig 12.1).
2.Slide bracket sleeve onto end of Support Bar[03] (Fig 12.2).
3.Slide bracket sleeve onto the anchor. Tighten two screws of the Wall Bracket [18] by
following sequence "b" , "a" (Fig 12.3).
4.Attach the Support Bar[03] to the inside of the Fixed Panel [10] with the Fasteners
[13] as shown in Fig 12.2. Ensure the Support Bar[03] is level. Use provided Allen
wrench to hand tighten (Fig 12.3, Fig 12.5).
5.Tighten two screws of the Wall Bracket [18] by following sequence "d" , "c" (Fig 12.6).
1
FH Screw
ST5X35
anchor
gasket
14
6
2
3
a
b
c
d