Full Product Manual

Step 19

1. If needed, the door height at each wheel can be individually adjusted by using the

Wrenches [21] .

a. For the Trolley Wheel[12], using wrenches[21] in the package to carefully loose the

nut for half turn. Rotate plastic nut as shown in Fig 20.1. This will raise or lower the

Door Panel [09] at this location so that the door panel can match the wall better. Fasten

the nut again after the adjustment.

b.For the Anti jump parts[14], using one wrench[21] to hold the nut and using the Allen

Key 2mm[23] to loose the nut for half turn. Rotate plastic nut as shown in Fig 20.2. This

will adjust the Anti jump parts[14] to fit the groove of the Support Bar[03] better.

2. Install the covers of the Trolley Wheel[12] (Fig 20.3).

plastic

nut

2 2a

see from the backward

Fig20

see from the backward