Full Product Manual

ATTENTION
.
To avoid personal injury or property damage, identify components and read all
instructions before installing.
This model requires a minimum 2-3/16"(55mm) of flat level threshold space for
installation. (Dimension "D" of Fig 2.)
The instructions below are for the option that fixed panel installed on the right.
Step 1
This shower door must be installed into a stud. Minimum threshold space is required.
IMPORTANT: Using a stud finder,ensure that the wall on both side of the enclosure has a
stud in the location shown. A stud in this location must be identified to support the support
bar and the wall jamb in order to proceed with the installation. If you do not have a stud in
this area shown, find a qualified person for advise.(Fig 2)
1. Measure in 3/16"(5mm) min from the outside of the Wall to the profile of the Wall Jamb
[02] or measure in 3/16"+ (A") if you want to install the shower door behind the outside of
the wall (Fig 1,Fig 2).
2. Using a pencil and stud finder to mark the location of all three screw holes for fixed
panel Wall Jamb [02] so that it can be fixed on the stud.
.
INSTALLATION INSTRUCTIONS
.
7
wall
wall jamb
3/16"
3/16"
threshold
OUTSIDE
D
Fig2
Fig1
wall
[02]
[02]
.
Wall Bracket [18]
must be installed
to the stud.