Instructions / Assembly

Step 13

1.lnstall Support Bar [02] to Wall Bracket Assembly. The groove of the Support Bar [02]

faces inward. Place a level to make sure the horizontal of the Support Bar [02].

2.lf the Support Bar [02] isn't horizontal, remove the Support Bar [02] again.

Find the higher Wall Bracket Assembly and loose the fixed screws for one turn .(Fig 17 .1)

3.Turn the hex screw counter-clockwise for one turn each time. Replace the

Support Bar [02] and level to check the horizontal.(Fig 17.2)

4. Tighten the screws which were loosen at step 13.2 again if the horizontal is confirmed.

5. Reinstall the cap of Wall Bracket Assembly and fixed with the Allen Key[22]

(Fig 17.1 and Fig 17.2).

Fig17