WALL PANELS INSTALLATION & CARE GUIDE SW-AZ008WH SW-AZ8075 Have questions? Visit us at www.ANZZI.com or call us at 1-844-44-ANZZI.
Preparation 1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece count with your packing slip. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are included in the package by checking offthe components on the "Detailed Diagram of Shower DoorComponents".
THREE WALL PANELS SIZE MODEL SPECIFICATION D1(in) D2(in) W(in) H(in) F(in) SW-AZ009WH 36"X60"X36"X74" 36" 36" 60" 74" 1.5" SW-AZ008WH 36"X60"X36"X60" 36" 36" 60" 60" 1.5" D2 W D1 H F TWO WALL PANELS SIZE MODEL SPECIFICATION D(in) SW-AZ005WH 60"X36"X74" 36" W(in) H(in) 60" 74" F(in) 1.
Wall Panels Installation-Preparation 1. Check the wall panels and the screw . See Fig. 1 for details 2. Make sure the stud and drywall have finished ,the shower base or bath tub is ok for build the wall panels.place silicone on the drywall first. See Fig. 2 for details screw Drywall Screw ST4x15mm 37+2 Fig. 1 Fig.
3. Place the center wall panels on the drywall. See Fig. 3 for details 4.Place the side wall panels(rigth and left) . See Fig. 4 for details Fig. 3 Fig.
5. Refer to the section for finished install . See Fig. 5 for details 6. Use silicone to fill the gap between wall panels and base(bath tub), also the gap between centre panel and side panel. use studs to support the wall panels for 24 hours. See Fig. 6 for details Stud Drywall Wall panel Silicone Base Fig. 5 24 Hours Wait 24 hours before using the shower Fig.