Installation Guide

INSTALLATION INSTRUCTIONS

Before you begin, read the installation instructions below. Observe all local building and safety

codes.

Unpack and inspect the product for any shipping damages and ensure that none of the required

pieces are missing. If you nd damages, do not install. Contact Customer Service at 1.866.44.

ANZZI. If you need assistance or have questions while installing your towel warmer, contact

Customer Service.

Anzzi™ accepts no liability for any damage to the towel warmer or wall, or for personal injury during

installation.

TOOLS AND MATERIALS

Safety glasses • Tape Measure • Level • Drill • Screwdriver • Pencil

WALL MOUNT INSTALLATION

1. Attach the wall supports to the towel warmer.

2. Using a level and tape measure, determine and mark the installation location of the wall

supports. Drill mounting holes and install wall anchors in these locations.

3. Secure the mounting brackets onto the wall using the provided mounting screws.

4. Hang and adjust the towel warmer onto the mounting brackets. Ensure the towel warmer is

rmly and safely xed.

5. Plug the towel warmer into the wall socket.

OPERATION AND MAINTENANCE

The red light indicates the towel warmer is in the on position. Always turn the power o when the

towel warmer is not in use.

Note: Fabrics that contain soap or detergent residue may show what appears to be scorch marks.

These marks are simply the discoloration of the residue.

Wall Mounted Towel Warmer Installation

PAGE 1
Wall Mounted Towel Warmer Installation INSTALLATION INSTRUCTIONS Before you begin, read the installation instructions below. Observe all local building and safety codes. Unpack and inspect the product for any shipping damages and ensure that none of the required pieces are missing. If you find damages, do not install. Contact Customer Service at 1.866.44. ANZZI. If you need assistance or have questions while installing your towel warmer, contact Customer Service.
PAGE 2
1.Angle measure 2.Tape Hammer (5) Plastic expander WARNING 5. spanner (4) Long screw nail (5) Plastic expander 4. Pencil (3) 4pc Bushes or 3pc Bushes +1pc spanner essories of square Accessories of round tubes 5.2.Angle short tube fortubes wall bracket Hammer 7. Drill A, B, C 3. "+" screwdriver (6) Short screw 6. Electric drill (5) expander allation Fittings: Needed tools (left of right): 7. Drill a pilot hole into (6) Plastic Short screw 1. As shown in the picture, 5.