User Guide
27 Page
Installaon
Installaon Manual
Remote controller
terminals
&]PXr
Two fork terminals
Remote controller cable
Inlet for the remote
controller cable
Cut out
&]PXr
X)d]PZv Z `} &}l u]vo beneath the two Zu} }v}oo u]vo screws,
which are not polarity-sensitive, on the back of the main body. ~&]PXr
X Cut out the inlet for the remote controller cable from the bottom of the main body. ~&]PXr
æX)Wo Z ^D]v }˙ ” back on the l o , with the Zu} }v}oo o running
out of the bottom inlet.
D,}` } }vv Z u} }v}oo } Z ` ZE
X)]}vv }` o˙ (}u Z ` ZX
X)dl }(( Z ` Z[ (}v }X
X)>} Z u} }v}oo u]voU ] o}` ~o} }v Z o}`
right-hand side of the computer board).
X)dl }(( Z l o (}u Z u} }v}ooU v Zv Z Z `} (}l u]vo }
connector base on the backside of the remote controller with two screws. Make sure the
terminals are firmly fixed.
æX)Woo Z u}[ `] Z}PZ Z Z}o Z }}u }( Z ` Z[ ]vPX
X)W}o˙ Z Z u}[ `] } Z u} }v}oo u]vo }v Z }u }
(No polarity).
) } EKd iu } Z}r]] Z `]U } Z }u `]oo uPX
X)Zo &}v } o˙X
X)t] (} Z u} }v}oo }vv]}v u W
{ Minimum 20 gauge wire (No polarity)
{ Maximum 400 ft. (122 m) long
ıııæ~dDrZ
}vv}Zv}Zu]vo