Install Instructions

www.hotwater.com 27
TERMINATION CLEARANCES SIDEWALL POWER VENT
INSIDE CORNER
DETAIL
FIXED
CLOSED
OPERABLE
FIXED
CLOSED
OPERABLE
Vent terminal
Air supply inlet
Area where is not permitted
Gas meter / regulator
C
B
B
B
B
B
J
A
K
M
F
B
L
E
D
I
V
V
V
V
V
V
V
V
V
V
X
X
X
G
A
Figure 29
Vent terminal clearances for “Power Vent” installations. Power Vent confi gurations use room air for combustion.
A
Clearance above grade,
veranda, porch, deck or
balcony
12 in. (30cm) H
Clearance to each side of
center line extended above
meter/regulator assembly
N/A
B
Clearance to window or door
that may be opened
4 ft. (1.2m) below or
to side of opening;
1 ft. (30cm) above
opening
I
Clearance to service regulator
vent outlet
3 ft. (91cm)*
C
Clearance to permanently
closed window
12 in. (30cm)* J
Clearance to a non
mechanical air supply inlet into
building or combustion air inlet
to any other appliance
4 ft. (1.2m) below or
to side of opening;
1 foot (30cm) above
opening.
D
Vertical clearance to ventilated
soffi t located above the
terminal within a horizontal
distance of 2 ft. (61cm) from
the center line of the terminal
12 in. (30cm)* K
Clearance to a mechanical air
supply inlet
3 ft. (91cm) above
if within 10 ft. (3m)
horizontally
E
Clearance to unventilated
soffi t
12 in. (30cm)* L
Clearance above paved
sidewalk or paved driveway
located on public property
7 ft. (2.13m) †
F Clearance to outside corner 2 ft. (60cm)* M
Clearance under veranda,
porch, deck, or balcony
12 in. (30cm) ‡
G Clearance to inside corner 18 in. (45cm)*
In accordance with the current ANSI Z223.1/NFPA 54, National Fuel Gas Code.
† A vent shall not terminate directly above a sidewalk or paved driveway that is located between two single family
dwellings and serves both dwellings.
‡ Permitted only if veranda, porch, deck, or balcony is fully open on a minimum of two sides beneath the fl oor.
* Clearance in accordance with local installation codes and the requirements of the gas supplier and the
manufacturer’s installation instructions.