Val NG: the information in this manual is not followed exactly a fire or explosion may result causing properly damage, personal injury, or death, — DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. "WHAT TOO MELLIFLUOUS GAS: = DO NOT try to light any appliance. ‘DO NOT touch any electrical switch. DO NOT use any phone in your building. Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
important safety information 3 Stainless steel surfaces 19 Overview 10 Control knobs 19 Dimension and clearance 10 Burner grates and components 20 Circuit Diagram 12 Burner caps and heads 20 Side &Back Panel Layout 13 Burner bases 21 What's included 14 Electrodes 21 Electrical Requirements 15 Grates 21 Using the cook top burners 15 Burner head and cap replacement 22 Ignition 15 Burner cap 23 Cookware 17 Troubleshooting 24 install the grates 17 Checkpoints 24 Care and cleaning of the cook top 18 Gas Cook top
Important safety information Read all instructions before using this appliance State of California Proposition 85 warning (US only) « All electrical and gas equipment with moving parts can be 0H WARNING dangerous. Please read the important safety instructions for this appliance in this manual. Ths instructions must be followed to minimize the risk of injury, death, or properly This product contains chemicals known to the Slate of California to cause cancer and birth defects or other damages.
Genera] safety Ah warning To reduces the risk of firs, electric shock, personal injuries, and/or death, observe the following precautions. » Do not touch any part of the cook top, including but not limited to cook top burners during or immediately after cooking. « Know the location of the gas shut-off valve and how to shut it off. « Make sure the hold down brackets are properly installed on the cook top. Ses the installation instructions for mare information. « Do not Ist children near the cook top.
Fire safety Ah WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. = Dao not store, place, or use flammable or combustible materials such as paper, plastic, pot holders, linens curtains, gasoline or other flammable vapors or liquids near the cockily. = Do not wear loos fitting or hanging garments while using the cookie. « To avoid grease buildup, regularly clean the vents.
Electrical and grounding safety A), WARNING To reduce the risk of fire, electric shook, personal injuries, and/or death, observes the following precautions. = Plug the power cord into a grounded 3-prong outlet. = Do not remove the grounding prong. = Dio not use an adapter or an extension cord. » Do not use a damaged power plug, power cord, of loose power auto. = Do not modify the prows plug, power cord, or power outlet in any way.
installation safety 4). WARNING To reduces the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. = Have your cookie installed and proper grounded by a qualified installer, in accordance with the installation instructions. Any adjustment and service should be performed only by qualified gas cook lop installers or service technicians.
Location safety Cook top safety 4). WARNING A WARNING To reduce the risk of fire, electric shook, personal injuries, To reduce the risk of fire, semicircle shock, personal injuries and/or death, observe the following precautions. and/or death, observes the following precautions. « This cook top is for indoor, household uss only. Do not install + Select varicolored that is designed for range top cooking. Use cookware the cookie in areas exposed to the weather and/or water.
+ Before removing or changing cookwares, tum off the boomers. « Remove food and cookware immediately after cooking. = Before removing any pairs of the bummer for cleaning, make sure the cook top is off and completely cool. = After cleaning the burner spreader, make sure it is completely dry before re-assembling. « To avoid carbon monoxide poisoning, do not pour water info the colophon well while cleaning.
UL-BKGCAM36-ST Circuit Diagram Swi swiz swa SSW SW5 Swe rd valve Tal Right Front Right Rear Middle Front Middle Rear Lat Front Left Rear Ignition pin INPUT: 120V/AG 80Hz Pulse ignition Paar Plug L (Black wire} H-6pin N (White wits} Peroration wire) G0 hd 777 Side &Back Panel Layout Each burner has a corresponding knob that leis you to set the flame level from addition, sate burner knob has a Lite setting. Turning a knob to Lite ignites the corresponding burner.
ELECTRICAL REQUIREMENTS Using the cook top burners Gas cookie requires 110 volts, 50/60 Hz electrical supply to Ignition operate the ignition system. g Ah WARNING A\ caution Electrical Grounding Instructions This appliance is skipped Make sure all cook top burners are properly installed. Statement of with a {three-prong {four-prong) grounding plug for your the gas supply pressure for checking the regulator ghastliness pressure stated shall be al least NG 5in 10in w.
To light a burner: 1. Turn anticlockwise to the ignite position, push in the control knob, the knob turns on and you will hear a “clicking” sound indicating the electronic ignition system is working properly. 2.After the cook top burner lights, turn the control knob to shift it out of the Lite position and turn off the electronic ignition system. 3.Turn the control knob to adjust the flames Laval. Manual ignition if there iz a power failure, you can ignite the burner manually. Use caution when doing this.
Cookware Requirements -Flat bottom and straight sides ~Tight-fitting lid “Well-balanced with the handle weighing less than the main portion of the pot or pan. Size limitations A\ caution +» Do not place a pan or pot with a bottom diameter of about 10 inches or more on the Left Front or Right Front boomer. « Always make sure cookware handles are turned to the side or rear of the cookie and not over other surface boomers.
To replace the grates correctly, follow these steps: 1.Locate the notch on the back of the right grate. 2 Orient the right grate so that i is on tha right side of the cookie with the notch in the back. 3.Gently lower the legs of the right grate into the corresponding dimples on the cook top. 4.
Stainless steel surfaces 1.00 not remove any spills, spots, and grease stains using 2 soft, wet cloth until surfaces is cool. 2.Apply an approved stainless steel cleanser to a cloth or paps towel. 3.Clean one small area at a ime, rubbing with the grain of the stainless steel If applicable. 4.when done, dry the surface using a soft, dry cloth. 5.Repeat steps 2 through 4 as many times as necessary. A CAUTION « Do not use a steel-wool pad or abrasive cleaner, which can scratch or damage the surface.
Burner grates and components Burner caps and heads Turn off all surface boomers and make sure they have NOTE all cooled down. 1. Remove the boomer grates. Before removing the boomer caps and heads, remember their size 2.Remove the burner caps from the bummer heads. and location. Replace them in the same location after cleaning. 3.Remove the bummer heads from the valve manifolds to sever! the Wash burner caps and bummer heads in hot, soapy water and rinse starter electrodes, with clean running water.
—burner bases A caution The burner bases cannot be removed for cleaning. Make sure that no water gets into the boomer bases and the brass gas orifices. Wipes clean with a damp cloth. Be careful not to scratch, deform, or damage the bass. Allow them to dry fully before using. Electrodes Do not attempt to remove the electrode from the cook lop or bummer bases. Be careful not to push in any cock lop controls while cleaning the cook top.
Burner head and cap replacement Round Burner head 1.Align the burner (point A) with the notch in the bottom B} 2. turn the burner over and cover tha bottom cup. A caution Make sure all bummest components {heads and caps) ara re-installed properly. Hay will be stable and rest flat when correctly installed, Burner cap 4.Match the burner caps to the boomers by size, and then re-install the caps on the bummer heads.
Troubleshooting i you encounter a problem with the cook top, check the tables starting below, and then try ths suggested actions. Checkpoints Gas safety You smell gas. The surface burner knob is notion the Turn the burner knob to OFF. OFF position and the burner is not lit. There is a gas leak. Clear the room, building, or area of all occupants. immediately call your gas supplier from a neighbor's phone. Do not call from your phone. iris electrical and could cause a spark that could ignite the gas.
Gas Cookie Conversion Tha cook top is set for use with Natural Gas (NG). The factory selling is indicated on the serial plate. When set for Natural Gassing) operation, the pressure regulator will regulate the gas to 4” inches water column pressure. When set for Liquefied Propane Nonoperational the pressure regulator will regulate the pressure to 11"inches water column. Please refer to Instructions for Converting colophon to Operate on Liquefied Petroleum Gas.
-BURNER DERANGEMENT Motel ruminate of gossip By mere bummers Left Front 18000 SHUT Lo Rear 12000 BUM Right Fran 2900 BTU Right Rear $000 BTU GOO000. UL-BKGCAM36-ST Iota! number of capeskin Bu mess Bummers Can bar Front 18000 BUM Center Rew 12000 BUM Left Front 16000 BUM Left Rest 12000 BTM Right Front 8000 BTU Right Seer 8000 8TH IMPORTANT: After replacing the natural gas to LP orifices, be sure fo keep the original factory installed natural gas orifices for future range conversion back to natural gas.
LF Formica Plastic Bao Tami Painting Fiasco Firs 1 BORE HE Ca 3083600018 2. Convert Burner for LP/ Propane Gas Save the natural gas orifices moved from the appliance for possible future conversions fo natural gas. You should rely on the following process when conversing unit back to Nature gas. Take sirrah care when handling orifice parts, making sure the orifice is not a.Remove top grates, boomer caps and inner boomer rings. b.Lift off outer burner heads and bums bases. ©.
—273.Convert Buber Valves for Propellant Sas INSTALLING THE COOK TOP 2, Tho interlocutor pan-head screw patios i thighs the interruption ding place, and twist the are to lack the countertenor. 4 1, Lase tha product on the deadlock, ans use tantalization directions of garlic direction of the twa Erse-shiapod fiat-goad craws ta x the destine hashish groove lu NG adjustment shaft groove is LP fixing device on the product bass. i One 5/64" flat screw driver is needed for the Bypass Adjustment on Burner Valve .
4.Reconnect Gas and Electrical Supply to Leopoldo. Leak testing of the appliance shall be conducted according fo the installation instructions provided wile the cook top. Checking for Manifold Gas Pressure necessary to check the manifold gas pressure, remove the burner cap, inner ring, wore burner head and boomer base of the right front top bummer and connect 8 manometer (water gauge) or another pressure test device to the burner orifice.
Thank you for choosing HOBOS! product. We sincerely hope that you are satisfied with it. a BALDRICS] Warranty ‘Card The manufacturer's warranty covers the product for a period of 12 months from the date of purchase against manufacturing faults. All Tent name warranties are automatically kept track of in our system, so there is Sheri * EEE no need to register your product. Store name: Distributorship is welcome to contact us. Emaitinfo@isoboPurthass dale: sitcom.
