User's Guide

Default MIDI mappings and general recommendaons
Your Sylphyo assumes a default pitch-bend range of ±2 semitones.
The following table summarizes the MIDI messages sent by the Sylphyo
for each of the parameters you control, with the default mapping (al-
though you may have to enable some of these parameters first). You
can always change these messages in the MIDI Mappings secon of
the Sengs menu.
Parameter Default MIDI message to map
Breath intensity CC 11 (Expression)
Slider control CC 1 (Modulaon)
Slider control (from top edge) CC 12 (Effect Controller 1)
Slider control (from boom
edge)
CC 13 (Effect Controller 2)
Elevaon angle CC 75 (Sound Controller 6)
Roll angle CC 76 (Sound Controller 7)
Compass direcon CC 77 (Sound Controller 8)
Key-bend (control) CC 78 (Sound Controller 9)
If you cannot use these mappings (e.g., with a simple Soundfont ex-
pander or sample-based synthesizer), you can at least configure the Syl-
phyo to use dynamic velocity: the velocity of the MIDI notes you play
will be commensurate to the intensity of your breath at the beginning
of the note. To do so, go to the MIDI Mappings secon of the Sengs
menu, and set the Velocity parameter to Dynamic.
33