User's Guide

Sengs
Breath
This secon allows you to setup the breath sensor of the Sylphyo.
Minimum
Set the minimum amount of breath intensity (in arbitrary units, between 0 and
3000) that will trigger a note start. Usually, you might want to decrease the
minimum to get the fastest response, or to increase it to avoid spurious notes.
Default: 20
Range
Set the dynamic range of breath intensity (in arbitrary units, between 0 and
3000). A lower value allows you to reach the maximum note intensity with
less air, while a higher value allows you more precise control of the breath
response.
Default: 600
Curve
Set the curve of the breath response, between Linear (more realisc), Logarith-
mic (faster response with less breath), and Lin-log (intermediate curve).
Default: Logarithmic
Filtering
Smoothen the data of the breath sensor, while keeping reacvity intact, to
avoid arfacts in some synths. If you play with a plug or cover some of the
exhaust hole, you do not need this seng, and we recommended to disable
it so that fast advanced techniques such as fluer-tonguing and growling can
be reproduced without any issue.
Default: Enabled
50