Operating instructions

ManualsBrandsAOG ManualsBurner3282 Series

REV 2 - 1401030955

L-C2-356

SAFETY WARNINGS & CODES

INSTALLER: Leave these instructions with consumer.

CONSUMER: Retain for future reference.

INSTALLATION AND OPERATING

INSTRUCTIONS

Important: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION

DANGER

IF YOU SMELL GAS:

1. Shut off the gas to the appliance.

2. Extinguish any open ﬂ ame.

3. Open cover.

4. If odor continues, keep away from the

appliance, and immediately call your

gas supplier or ﬁ re department.

WARNING

1. Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the

vicinity of this or any other appliance.

2. A propane cylinder not connected for use

shall not be stored in the vicinity of this

or any other appliance.

CODE AND SUPPLY REQUIREMENTS: This

appliance must be installed in accordance with

local codes and ordinances, or, in the absence of

local codes, with either the latest National Fuel Gas

Code (ANSI Z223.1/NFPA 54), and Natural Gas and

Propane Storage and Handling Installation Code

(CSA-B149.1).

This appliance and its individual shutoff valves

must be disconnected from the gas supply piping

system when testing the system at pressures in

excess of ½ psig (3.5 kPa).

This appliance must be isolated from the gas

supply piping system by closing its individual

manual shutoff valves during any pressure

testing of the gas supply system at pressures

up to and including ½ psig (3.5 kPa).

All electrical outlets in the vicinity of the appliance

must be properly grounded in accordance with local

codes or, in the absence of local codes, with the

National Electrical Code, ANSI/NFPA 70, or the

Canadian Electrical Code, CSA C22.1, whichever

is applicable.

Keep all electrical supply cords and fuel supply

hoses away from any heated surface.

WARNING

Improper installation, adjustment, alteration,

service, or maintenance can cause injury or

property damage. Refer to this manual. For

assistance or additional information consult

a qualiﬁ ed professional installer, service

agency, or the gas supplier.

DOUBLE SIDEBURNER

3282 Series

American Outdoor Grill • PO Box 4053 • La Puente, CA 91747

11-38

Certiﬁ ed to: ANSI Z21.58b-2012

CSA 1.6b-2012

Summary of content (16 pages)

PAGE 1
DOUBLE SIDEBURNER 3282 Series INSTALLATION AND OPERATING INSTRUCTIONS INSTALLER: Leave these instructions with consumer. CONSUMER: Retain for future reference. Important: READ THESE INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION SAFETY WARNINGS & CODES WARNING DANGER IF YOU SMELL GAS: 1. 2. 3. 4. 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2.
PAGE 2
SÛRETÉ ET CODES D’AVERTISSEMENT INSTALLATION INSTRUCTIONS ET MANUEL DU PROPRIÉTAIRE DANS LE CONTRE- DOUBLE SIDEBURNER DANGER: AVERTISSEMENT: SI VOUS SENTEZ LE GAZ : 1. C o u p e z l ’ a d m i s s i o n d e g a z d e I’appariel. 2. Éteindre toute flamme nue. 3. Ouvrir le couvercle. 4. Si l’odeur persiste, éloignez-vous de l’appareil et appelez immédiatement le fournisseur de gaz ou le service d’incendie. 1.
PAGE 3
DOUBLE SIDEBURNER PARTS LIST Item 1. 2. or 3. 4. 5. 6. 7. 8. Part No.
PAGE 4
PREPARING FOR INSTALLATION WHERE TO INSTALL YOUR DOUBLE SIDEBURNER Important: FOR OUTDOOR USE ONLY. Your double sideburner is designed to complement your grill. It provides a convenient, efficient cooking surface for side dishes that require bottom heat only. TOOLS REQUIRED The double sideburner has been pre-assembled. You need only a pair of wrenches, pliers, or vice grips for the gas connection. Do not install this unit under unprotected flammable surfaces.
PAGE 5
PREPARING FOR INSTALLATION (Cont.) A REGULATOR MUST BE PROVIDED AT THE The gas supply pipe connection is to be made BOTTLE OR GAS SOURCE FOR USE WITH through the floor at the rear of the enclosure. PROPANE GAS. Install the gas line stub at least 2" away from the side walls and 1" from the back wall, but within 5" 22 23 3/4" 3/4" of the back wall, as illustrated by the shaded area 1" X in Fig. 5-1.
PAGE 6
INSTALLATION (Cont.) f. If an orifice change is necessary, replace the orifice with the correct sized one. e. Close the dedicated gas-supply shut-off valve, then slide the grill into place. Do not to pinch, kink, or damage the gas connector line. g. Replace the sideburner tube over the orifice, aligning the burner over the electrode, taking care not to detach it from the wire. h. Replace the burner retaining clip (underneath Note: Each side of the unit has a tab just behind the control panel.
PAGE 7
AIR SHUTTER ADJUSTMENT Air shutters are preset at the factory based on the gas the sideburner is built to burn. However, altitude or other local conditions may require air shutter adjustment for proper combustion. 4. Loosen the front burner air shutter adjustment screw, then use the tip of a screwdriver to open or close the air shutter until the flames appear blue and touch the burner ports. The flames from a properly adjusted sideburner will touch the burner ports and appear mostly blue. 5.
PAGE 8
NOTES PAGE Please use this page to record any information about your unit that you may want to have at hand.
PAGE 9
LIGHTING (IGNITION) INSTRUCTIONS Read all instructions before lighting, and follow these instructions each time you light the unit. ELECTRONIC LIGHTING MANUAL LIGHTING Note: Electronic lighting requires an installed 9-volt battery with a good charge. CAUTION: Always wait five (5) minutes for gas to clear after any unsuccessful lighting attempt. 1. Open lid(s) or remove cover(s) from burner(s) to be lit. 2. Turn all gas control knob(s) to their OFF position(s). 2.
PAGE 10
ALLUMAGE DES INSTRUCTIONS (D’ALLUMAGE) Lisez toutes les instructions avant l’allumage, et suivez ces instructions chaque fois vous lumière le unité. ÉCLAIRAGE ÉLECTRONIQUE Note: ÉCLAIRAGE MANUEL L’éclairage électronique exige une batterie installée de 9 volts avec une bonne charge. RRN O SUTU TO ATTENTION: Attendez toujours cinq (5) minutes le gaz pour se dégager après que n’importe quelle 1. Ouvrez les couvercles ou enlevez les couvertures des brûleurs tentative non réussie d’éclairage.
PAGE 11
SAFE USE & MAINTENANCE OF PROPANE GAS CYLINDERS IMPORTANT FOR YOUR SAFETY READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER. When operating this appliance with a propane-gas cylinder, these instructions and warnings MUST be observed. FAILURE TO DO SO MAY RESULT IN A SERIOUS FIRE OR EXPLOSION. CYLINDER/CONNECTOR REQUIREMENTS a. Propane-gas cylinders, valves, and hoses must be maintained in good condition and must be replaced if there is visible damage to either the cylinder or valve.
PAGE 12
UTILISATION SÛRE ET ENTRETIEN DES CYLINDRES DE GAZ DE PROPANE IMPORTANT POUR VOTRE SÛRETÉ LISEZ ET SUIVEZ TOUS LES AVERTISSEMENTS ÉQUIPÉS DE VOTRE CYLINDRE DE GAZ DE PROPANE. En actionnant cet appareil avec un cylindre de gaz de propane ON DOIT observer ces instructions et avertissements. LE MANQUE DE FAIRE AINSI PEUT AVOIR COMME CONSÉQUENCE UNE INCENDIE OU UNE EXPLOSION SÉRIEUSE.
PAGE 13
CARE & CLEANING APPLIANCE MUST BE COMPLETELY COOL WHEN CLEANING. DO NOT SPRAY ANY CLEANER OR LIQUIDS ON THE APPLIANCE WHEN HOT. The appliance must be cleaned as often as once a month (depending on use) to prevent grease build-up and other food deposits. Wipe with grain INTERIOR THE BURNER PORTS AND CARRY-OVER PORTS/ SLOTS MUST BE KEPT CLEAN TO ENSURE PROPER IGNITION AND OPERATION. Fig. 13-1 - Wipe with grain Remove the burner (see orifice changing instructions) and clean the ports and slots as required.
PAGE 14
CHECKING AND CONVERTING GAS TYPE This unit comes from the factory configured for one type WARNING of gas, as marked on the label located behind the control HAZARDOUS OVERHEATING WILL OCCUR IF A panel, or on the interior of the unit’s enclosure. NATURAL-GAS ORIFICE IS USED WITH PROPANE Converting this unit to burn a different type of gas GAS. IF YOU ARE NOT SURE IF THE CORRECT requires a conversion kit (contact your dealer for ORIFICES ARE INSTALLED, OR IF AN ORIFICE details).
PAGE 15
REPLACING THE IGNITOR BATTERY 1. Remove the ignitor cover by turning it counterclockwise. Note: If you have accidentally removed the rubber cap, follow the instructions below to replace it. Important: Do not attempt to pull or turn the rubber cap. WRONG!! 2. Remove batter y for replacement. The battery is reinstalled with the negative (-) end out. 3. After properly inserting the battery, replace the ignitor cover by turning the cap clockwise. 1. Pull the rubber cap and the inner plastic sleeve apart.
PAGE 16
WARRANTY AMERICAN OUTDOOR GRILL LIMITED WARRANTY American Outdoor Grill warrants your grill to be free from defects in material and workmanship. American Outdoor Grill stainless-steel burners are warranted for FIFTEEN (15) YEARS. All other American Outdoor Grill parts are warranted for TEN (10) YEARS. (Except as noted below.) American Outdoor Grill infrared burners and vaporizer panels are warranted for THREE (3) YEARS.