Energy Guide

Page 14 of 104 Report No.: HK2107050725-SR
UL 507
Clause Requirement + Test Result - Remark Verdict
TRF No. UL507A
10.4.1 A means of disconnection – such as a cord
connector in conductors between the motor and
the base of an oscillating fan – shall be such that
live parts are not exposed under intended
conditions.
P
11
Mechanical Assembly
P
11.1
An appliance shall be assembled so as not to
increase the risk of injury to persons. Brush caps
shall be tightly threaded or otherwise constructed
to prevent loosening.
P
11.2
A switch, a lampholder, an attachment-plug
receptacle, a motor-attachment plug, or similar
component shall be mounted securely, and shall
be prevented from turning or shifting. See 11.3.
N/A
11.3
The means for preventing turning, as required by
11.2, shall consist of more than friction between
surfaces. For example, a toothed lock washer that
provides spring take-up, applied as intended, is an
acceptable means for preventing a small stem-
mounted switch or other device having a single-
hole mounting means from turning.
N/A
11.4
Internal connections that must be made in the
field in a cord-connected appliance that is shipped
partially disassembled shall be made by plug and
receptacle connections. Internal connections that
must be made in the field in an appliance
intended for permanent connection to the power
supply and shipped partially disassembled shall
be made with means that comply with
requirements for field wiring in accordance with
14.3.5 or by plug and receptacle connection.
P
11.5
Unless the intended method of assembly is
obvious, an appliance that is shipped from the
factory partially disassembled shall be provided
with clear and detailed assembly instructions.
P
11.6
An appliance that is shipped from the factory
partially disassembled and is not marked in
accordance with 80.4.1 shall be shipped in a single
shipping container.
P
11.7
Uninsulated live parts of a thermostat provided with
a welded stop shall not contact a dead metal part or
parts of opposite polarity when breakage of the
welded stop permits the thermostat to rotate.
P
12
Mounting Means
P
12.1
General
P
12.1.1
An appliance, other than as noted in 12.2.1 –
12.2.3, is to be mounted in accordance with the
mounting requirements specified in the appropriate
section of this Standard.
P